As noted earlier, one of the important features of GPR equipment is the high resolution, especially within the first few meters, where medium-to-high frequency antennas are applicable. Some quality control experiments conducted on civil engineering structures or roads require centimetre, and sometimes millimetre, accuracy in both vertical and horizontal planes [9,10]. In GPR systems, a precise horizontal positioning is usually provided by an odometer, commonly a survey wheel. This device should be compatible with the system and software used for data acquisition and properly calibrated. The calibration should preferably be based on a long distance, in order to minimize errors in horizontal positioning.
An accurate vertical positioning is determined by both an adequate setting of the time zero of the two-way travel time scale and a proper estimation of the medium velocity in which the signal propagates. This velocity will provide a correlation between obtained signal’s propagation time and the range.Previous studies have shown that the time zero of the radargrams is not necessarily a fixed value, as it depends not only on each particular antenna and the distance between transmitter and receiver, but also on the electromagnetic properties of the medium located just beneath the antenna [11,12].To better understand our system and the emission characteristics of two bow-tie GPR antennas with nominal frequencies of 800 MHz and 1 GHz, we have conducted a series of tests following a methodology proposed by Rial et al. . As a result, we performed a detailed analysis of the emitted wavelet in the time and frequency domains.
In addition, according to the recommendations made by Yelf , a time zero is determined for each antenna in order to improve accuracy in range estimations of the reflectors detected by the radar.2.?Antenna CharacteristicsThe antennas under test (AUT) are two GPR shielded antennas with central frequencies of 800 MHz and 1 GHz Anacetrapib respectively, manufactured by Mala Geoscience [Figures 2(a-b)]. These are ground-coupled biestatic antennas of the bowtie type.Figure 2.Antennas under test. (a) 1 GHz antenna. (b) 800 MHz antenna. (c) Composite radiation pattern of a ground-coupled shielded antenna.Although each evaluated antenna appears to be a single unit, most GPR systems use separate antennas for transmission and reception, known as the biestatic configuration.
This biestatic configuration is used because it is not yet possible to obtain ultra-fast transmit-receive switches that operate in the sub-nanosecond region with sufficiently low levels of isolation between transmit and receive ports . The need to use separate transmit and receive antennas causes a convolution of the separate radiation patterns, forming a composite pattern [Figure 2(c)]. In this sense, the effective wavelet recorded is dependent on the characteristics of both dipoles, not only the transmitter.