013 m. It was assumed that the maximal error of angle determination in this study was for a segment length of 0.55 m, at about 3.6 degrees. The precision limits for these angle measurements GW 572016 resulted predominantly from the inexactness in determining the ankle, hip and shoulder reference points; an athlete in his suit is not a rigid body. Associated with this are angle measurement precision errors of typically 1�C2�� (Schm?lzer and M��ller, 2005). A six-link bilateral model was created (left ski, right ski, trunk, arm, thigh, shin) based on nine joint points (top of the skis, end of the skis, shoulder joint, distal arm joint, hip joint, knee joint and ankle joint) (Picture 2). Picture 2 The 2-D model of nine jumper��s body and skis points used in digitising The data were manually digitised by an experienced technician.
The changes of body and ski positions were mostly determined with respect to the horizontal plane. The set of eight kinematic variables was constructed (Figure 1). Figure 1 Set of kinematic variables at 15m behind the jumping hill edge; �� G- Angle between left skis and leg; ��T- Angle of hip extension; ��LR- Angle between upper body and left arm; ��N- Angle between left leg and horizontal axis; … Statistical analysis of all multi-item variables was performed to determine mean values (M) and standard deviations (SD). Pearson��s linear correlation coefficients (r) were computed. P-values of less than 0.05 were accepted as statistically significant. Factor component analysis was used to determine the common variance between the dependent multi-item variable length of jump and the chosen independent multi-item kinematic variables.
The following parameters were calculated: Fnp �C factors value of each manifest variable on extracted factors, F CUM �C cumulative factors value of each manifest variable of all extracted factors, % of TV �C percentage of total variance of all extracted factors. Results All correlation coefficients between the dependent multi-item variable length of the jump and the independent multi-item variable vertical height of flying (Table 1) were statistically significant (p<0.05). High factor projections of both multi-item variables vertical height of flying and length of jump existed in the first common factor, which explained 69.13 % of total variance. Statistically significantl (p<0.
05) coefficients of correlations between the multi-item variable angle between the body chord and horizontal axis and length of jump were reached. A high level Dacomitinib of total variance (TV=65.04%) was seen in the first common factor. Also statistically significant correlation coefficients existed between the multi-item variable length of jump and the angle between the left leg and the horizontal axis. The variability of these coefficients was not high. The explained common variance (TV=61.88%) in the first factor was above 50 % of the total variance.